1

Topic: I ask for suggestions in a problem with the winchester

Misters;
I will be grateful to recommendations in the following problem:
In the computer 2 SATA the winchester, 500 and 1000 GB. Everyone is broken into 2 logical. 8 GB . From the assembly  4 years ago costs 64-ehbitnaja Windows 7. The mode for screws in a BIOS has been specified IDE.
Yesterday decided to change it on AHCI. In a branch of register HKEY_LOCAL_MACHINE\System\CurrentControlSet\servic es\msahci value of parameter Start changed with 3 on 0. Rebooted, entered into a BIOS, changed SATA Mode with IDE on AHCI.
Windows booted, installed new the driver, told that all , asked reboots. , all works.
Approximately in an hour  here such window:
[img=556x493, 43.8Kb] http://searchengines.guru/attachment.ph … 1482154524 [/img]
The screw not new, was bought about 7 years ago. The Most important data from it copied. Though, for certain not all and something remains in back streets. A question: than it is possible to check up the winchester and to try to understand in what a problem? Whether has sense to return to mode IDE?

2

Re: I ask for suggestions in a problem with the winchester

SergejFedosov
The Most important data from it copied
Now copy the least important
Than it is possible to check up the winchester and to try to understand in what a problem?
Smart show
Whether Has sense to return to mode IDE?
No. Or simply coincided, or in IDE it was impossible to look at a smart

3

Re: I ask for suggestions in a problem with the winchester

The window with warning Windows jumped out at each reboot. Rolled away the register and  in mode IDE - the window disappeared. But desire it is necessary to understand.
lamer
A smart show
Here:
http://searchengines.guru/attachment.ph … 1482163848 [off] (697x846, 34.9Kb) [/off]

4

Re: I ask for suggestions in a problem with the winchester

It is filled up B8 (184) - end to end.
At Samsunga come across not compatibility with some  in AHCI a mode.
Here only experimentally to clarify, change school desks, the version , the driver. Or to return again on IDE a mode.

5

Re: I ask for suggestions in a problem with the winchester

Alas, but IDE a mode again the window jumped out. (
Adding from 12/19/2016 19:32:
Tomset
It is filled up B8 (184) - end to end.
At Samsunga come across not compatibility with some  in AHCI a mode.

That is with a disk all is normal?
Adding from 12/19/2016 19:34:
Tomset
Here only experimentally to clarify, change school desks, the version , the driver.
Tell, please, and how in this case to supervise result of experiments? How the window with the warning ceases to jump out - means it turned out?) or under any data in a smart?

6

Re: I ask for suggestions in a problem with the winchester

SergejFedosov
With a disk all is normal?
Yes. Esteem some messages, beginning from here (very similar situation): Questions to experts o S.M.A.R.T. (A part 4), #4325
Back-up copy + ESwin + Initialize +...
Adding from 12/19/2016 19:36:
This attribute SMART should be dropped in an initial state (a disk ). To supervise then so that the number of these errors did not grow.