1

Topic: The new motherboard and the old power unit

Took new mother -
The connector 24pin on a supply also is still a connector 8pin "ATX 12V 2X4"
The power unit old 300 watt - 20pin also is separately 4pin the plug.
Couples mother - cyclical restart is not launched
And it is visible on  - the cooler stops and starts
Checked also without  and storages.
The speaker is not present - there is a LED on mother.
In the beginning completely goes out after the first switching-on, then burns but that is more feeble that more strongly
Does not approach ?
It is necessary to take on 24  and 8 ?
In descriptions it is written

wrote:

ATX_12V_2X4/ATX (2x4 12V Power Connector and 2x12 Main Power Connector)
With the use of the power connector, the power supply can supply enough stable power to all the components
on the motherboard.
Connect the power supply cable to the power connector in the correct orientation.
The 12V power connector mainly supplies power to the CPU.
If the 12V power connector is not connected, the computer will not start.
To meet expansion requirements, it is recommended that a power supply that can withstand high
power consumption be used (500W or greater). If a power supply is used that does not provide the
required power, the result can lead to an unstable or unbootable system.

Connected in 8pin slot 4pin - but the problem remained.
500 I so understood it is required for extensions of everyones

2

Re: The new motherboard and the old power unit

Yes, it is necessary to take the new power unit.

3

Re: The new motherboard and the old power unit

firms Pouha Minajl wrote:

does not approach ?
It is necessary to take on 24  and 8 ?

it is logical, if if it is necessary for a board 24  and 8   should be such.

4

Re: The new motherboard and the old power unit

wrote:

it is necessary to take firms Pouha Minajl on 24  and 8 ?

It is necessary to take qualitative  demanded capacity. Till now did not face, that 20  the connector was guilty, it quite to itself(himself) is stuck in 24  on mother and works. To thrust it it is irregularly possible unless with . Yes, if percents not the most low in a series it is recommended not to neglect  contacts on a supply and to take 24+8 (if there is a plug-in video card not to forget and  contacts for it).

5

Re: The new motherboard and the old power unit

Tried  24+4, truth 360 .
Another did not appear near at hand
The same song.
There is to percents, a storage 4 , video built in
It is necessary to buy  watt on 600, 24+8.
Though prompts that put most likely not in .
It should be launched on a minimum configuration.

6

Re: The new motherboard and the old power unit

Here my problem
http://forum.gigabyte.ru/viewtopic.php? … 76b0af87f5
Only mother another, gigabyte b250m-d3h
Let's read.
There is still a suspicion on storage, is not supported,
On a site in the specification there is no my lath

7

Re: The new motherboard and the old power unit

It was not possible to win
Replaced , took 500 watt with 4+4
Replaced storage
Similar mother . are shone
The speaker is silent.
Tomorrow I will go to hand over