1

Topic: Peep after setting new SSD

Installed in system new SSD. From  any thin electronic peep, apparently, in the core began to be distributed at disk loading. But in SSD like there is absolutely nothing to peep?... <<RSDN@Home 1.0.0 alpha 5 rev. 0>>

2

Re: Peep after setting new SSD

CM> Installed in system new SSD. From  any thin electronic peep, apparently, in the core began to be distributed at disk loading. But in SSD like there is absolutely nothing to peep? Chokes can peep. And not SSD, and  which suddenly began to receive loading on a line on which before it did not load (well, there, 5 can more it it is necessary).

3

Re: Peep after setting new SSD

Hello, SkyDance, you wrote: SD> And not SSD, and  which suddenly began to receive loading on a line on which before it did not load (well, there, 5 can more it it is necessary).  on 700 watt, capacities should suffice with interest. I hope, it not a sign that the fur small animal comes nearer to mine .... <<RSDN@Home 1.0.0 alpha 5 rev. 0>>

4

Re: Peep after setting new SSD

CM>  on 700 watt, capacities should suffice with interest. I hope, it not a sign that the fur small animal comes nearer to mine . In most cases 700 W is on output pressure 12 (because the overwhelming majority of capacity undertakes with this pressure). Whereas 5 and the more so 3.3, can be restricted by very modest values. Type 50 of W or at all 20 W.

5

Re: Peep after setting new SSD

Hello, SkyDance, you wrote: SD> Whereas 5 and the more so 3.3, can be restricted by very modest values. Type 50 of W or at all 20 W. Yes at me like there is nothing so strongly to guzzle. Pair SSD, pair of hard disks on 2.5"... <<RSDN@Home 1.0.0 alpha 5 rev. 0>>

6

Re: Peep after setting new SSD

CM> Yes at me like there is nothing so strongly to guzzle. Pair SSD, pair of hard disks on 2.5"So for peep just also it is necessary a little to guzzle. If to guzzle much, will be heated and fuse (though, more likely, simply to be ungeared - in modern  there are protection against too high current).

7

Re: Peep after setting new SSD

Hello, SkyDance, you wrote: SD> So for peep just also it is necessary a little to guzzle. If to guzzle much, will be heated and fuse (though, more likely, simply to be ungeared - in modern  there are protection against too high current). That is anything terrible also it is possible to hammer simply? Irritates, truth...... <<RSDN@Home 1.0.0 alpha 5 rev. 0>>

8

Re: Peep after setting new SSD

CM> That is anything terrible also it is possible to hammer simply? Irritates, truth... C anything if only not to consider terrible irritation. Peep of chokes always enraged me.

9

Re: Peep after setting new SSD

CM> Installed in system new SSD. From  any thin electronic peep, apparently, in the core began to be distributed at disk loading. But in SSD like there is absolutely nothing to peep? google-> ' SSD peep '-> really peeps. Actually in radio electronics  that can peep, and not just chokes. Condensers for example peep simply on hurrah. Electrolytic, film, and, especially,  (X7R/X5R/Y5V). The ceramics does not peep unless NP0. In this case I put on ferroelectric ceramics.  it is direct enrages - it is possible to try to disassemble and solder a polymeric electrolyte on a supply line right after a connector

10

Re: Peep after setting new SSD

Hello, CoderMonkey, you wrote: CM> Installed in system new SSD. From  any thin electronic peep, apparently, in the core began to be distributed at disk loading. But in SSD like there is absolutely nothing to peep? Couple of months back from mine  terrible peep started to be published. In half an hour of searches, the reason has been found - at stationary phone which was a row and in an emphasis not noted, the tube has not been supposed