Help to repair or throw out Transcend T3K 8Gb.
About a year successfully worked as a system disk in the Linux-car. Has been then replaced by a "high-grade" disk. However, right after changeovers, the flash card refused to work - in Windows is defined as a disk in volume 0 (i.e. the letter is appropriated, and further - anything to make with it does not give). Fdisk and to it similar (including from Linux') a disk cannot open:
usb 2-2: new high speed USB device using ehci_hcd and address 5
usb 2-2: New USB device found, idVendor=058f, idProduct=1234
usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
usb 2-2: Product: Mass Storage Device
usb 2-2: Manufacturer: Alcor Micro
Initializing USB Mass Storage driver...
scsi10: usb-storage 2-2:1.0
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
scsi 10:0:0:0: Direct-Access Generic USB Flash Disk 7.76 PQ: 0 ANSI: 2
sd 10:0:0:0: Attached scsi generic sg5 type 0
sd 10:0:0:0: [sde] Attached SCSI removable disk
Unable to open/dev/sde
Decryption usbflashinfo more low:
Possible memory chip (s):
Samsung K9LBG08U1M *2
Memory type: MLC
Vendor (by VID): Alcor Micro
Product (by PID): None
Manufacturer: Alcor Micro
Product: Mass Storage Device
Query Vendor ID: Generic
Query Product ID: USB Flash Disk
Query Product revision: 7.76
Physical disk capacity: 0 Bytes
Windows disk capacity: 0 Bytes
USB version: 2.00
Max. power: 100 mA
Data on a flash card is not necessary, as well as a flash card, in general... But if there is its possibility to "repair" - would be remarkable (after all 8Gb - quite adequate volume for today).
Yes, the flash card is very miniature, soldered and does not understand. Except 4 contacts USB in it more no communication with an external world is present...
In advance thanks!