2,901

Re: Repair USB flash drive (a part 02)

I thrust once in such  USB-port - burned down the controler.

2,902

Re: Repair USB flash drive (a part 02)

miha2154
I thrust once in such  USB-port - burned down the controler.
What is such and where it is possible to take.
Type on radio the market or not.

2,903

Re: Repair USB flash drive (a part 02)

What is such

on what Toshiba it is written.

Where it is possible to take. Type on radio the market or not.

Well type yes. And what for -  that you can? Whether and in it at you put... At me it was heated as a dog, and at you another.

2,904

Re: Repair USB flash drive (a part 02)

UNION OF RIGHT FORCES.
That I can solder, was engaged in repair of TV sets earlier, but whether there is now a sense.
P.S.  for a canoe this small, near the controler, the square-topped black:
TXC 12.0 MK7C

2,905

Re: Repair USB flash drive (a part 02)

And the devil only knows - it is not visible. The generator (on it "12" too it is written) can, and the supply stabilizator can.

2,906

Re: Repair USB flash drive (a part 02)

Pavel_2
TXC 12.0 MK7C
The quartz resonator, it was clear and without this link
http://www.txc.com.tw/
In this branch there are answers and questions similar to yours.
We take in hands a multimeter and it is measured an input and .
Why  that is heated? Correctly  through it brings down, that that does not allow you  consumption? And to proceed on a circuit from this ?
[off] All becomes on time and two. At you there two details serious - it not a telesight [/off]

2,907

Re: Repair USB flash drive (a part 02)

In 2009 bought a flash card 4GB STRA07KC,  upper 2Gb, solved  on a low level,
Took out from the case, learned chips: controler Chipsbank CBM2090 B81490-08E,
2 M a C ' 06 e3 29F16G08CAMB2 074417,
But near USB  unintentionally broke off resistor R2 (near condenser C1).
It is possible to solder new R2. Please, prompt R2  approximately.
Board CBM081219 (2090MLC) XY-Exigo differs  the second  from this board:
[img=505x143, 17.9Kb] http://flash-extractor.com/forum/files/4581_img126.jpg [/img]

2,908

Re: Repair USB flash drive (a part 02)

Is available  on AU6986 with two banks 29F64G08CAMD2 (0932 15)
VID and PID it is not defined (0000) tried a heap different AlcorMP - does not see. What prompt?
Itself  so it is jammed that is not visible the vendor, but known volume - 16 Gb. On a board there are inscriptions:
rev.03 09.02.14
um0 (Or 6) 3 - (two letters) 6986 (lga)
(Outwardly it is similar on PQI 16GB Traveling Disk U172P)
To short contacts yet did not try, but there is what that a difference on what  storages it to do?

2,909

Re: Repair USB flash drive (a part 02)

Skromnjaga
VID and PID it is not defined (0000)
In a test mode translate.

2,910

Re: Repair USB flash drive (a part 02)

ck.ua :
Skromnjaga
VID and PID it is not defined (0000)
In a test mode translate.

How?
In the meantime I found what feet to short on , tried - the result is not present. Truth I tried to do it on 7-ke (), access to  will be tomorrow afternoon.

2,911

Re: Repair USB flash drive (a part 02)

Here such situation... (
There is a flash card on 8gb, intel
Now disassembled, therefore controler number alcor AU6983hl-1
VID: 058F
PID 6387
Flash Type: JS29F64G08CAMD 1/2
(One chip)
AlcorMP_UFD v10.10.26.03
It was necessary to make cdrom section (before all was normal) but in process the program has been at the wrong time closed - because of auto update the computer rebooted
As a result the flash card in  is defined by volume 0 byte (in properties of drivers id USB\VID_058F&PID_1234
)
alcor_mp At Start' does read bad block 0 - 100 % and then writes an error
"0000: Read BadBlock Table Error
Bad Block 0/16384"
Whether it is possible to recover a flash card, and if yes that as?
Thankful in advance

2,912

Re: Repair USB flash drive (a part 02)

Here a miracle the flash card, a computer sees asks formatting
On it it is written  4
If it is possible decrypt.
2b2bqafjdfbb8d96899adfced1cfcffa
depcsfuhhgqiwoj#bo
aaaaaahzvue#krhaq#odvjt#zobo
sabaeh3u2*34o
ptszg4eehgqiwojbo
aaaab6h999998
gndwm#kqbubc97saaend
deff

2,913

Re: Repair USB flash drive (a part 02)

SilicomPower 16Gb stood in a handheld computer, USB\VID_058F&PID_6335&REV_0102
it does not see, the computer sees, reads, but to delete  a flash card cannot, writes that it is necessary to remove write protection, the write protection switch is opened. Tried pieces of 5 different programs,  does not see a flash card (((can for   the specific program is necessary, tried on Wines 7 and on Wines , under the administrator, tried with  to swing a site utilities, they also do not see a flash card. Help please.

2,914

Re: Repair USB flash drive (a part 02)

The answer , it is fine not , left on a warranty... I so understood this  is only at repairmen, to make it in any way, and to buy I do not want, not often such.